Jun 14, 2009 · Re: How do you tell if Gimble Bearing is going bad? I had the same growling noise from the stern and replaced the gimble bearing and it is pretty quiet now. But I still have a vibration and …

Jul 9, 2013 · Re: Volvo Penta SX-M Bellows and Gimbal Bearing Install Step-By-Step Here is a picture of both bellows removed This a where the u-joint bellows failed The only thing left to remove was the …

Mar 12, 2011 · Re: mercruiser a1/gen 2- removing gimball ring without removing outer transomplate a Pull the drive off, remove the trim position and trim limit sensors, remove the hinge pins and dont …

Dec 19, 2010 · anyone have any experience with diagnosing steering arm play on alpha 1? the outdrive moves a considerable amount without the steering arm moving inside the transom. i'm not sure if it's …

May 21, 2011 · Is there a wrong direction?? What year of drive are you working on? Some of the older gimble housings didn't have a zerk to grease the gimble bearing. You want the carrier "slots" facing …

Mar 16, 2016 · What can I expect to pay to replace bellows and gimball bearing on my Alpha 1 gen 2 outdrive? I already have the parts, just wondering the amount of time/$$ a marina might charge me. …

May 25, 2010 · No expert here, just trying to understand things. Why would this bearing need to "gimble"? That is what the 2 sets of ujoints are for, I thought. The gimbal bearing is in the gimbal …

Apr 17, 2022 · I am in the process of putting my whole Alpha One gimbal housing assembly back together. Every component of it has been gone over, repaired, serviced, painted. Anything that was …

Oct 20, 2010 · Re: Gimbal Ring replacment Bravo 3 I used the JR set up when I had to do my B3 gimbal ring. It worked great. If you think that the JR method or the Mercruiser "frankenstein" plugs is …

Apr 2, 2025 · This is a complete new engine and sterndrive install including new transom stringers etc- all measurements accurately measured according to the drawings and I don't think that even …